Building instructions and instructions for a whirlpool

What you need:

• Water hose
• Concrete or tiles
• Kit (tub, nozzles, suction technology)
• Spirit level
• Electrical connection
• Water inlet
• Water drainage

Things to know about the whirlpool according to instructions

If you want to build a whirlpool according to the instructions, you need significantly less space than if you wanted to build a swimming pool. This is also significantly cheaper in terms of costs, because you need a lot less water (a few hundred liters are enough) and therefore need less heating. Follow these instructions.

• The water in the whirlpool should be at least 30, or even better, 40 degrees. In order to implement this skillfully, you have to take into account high hygiene requirements. It is advisable to do this before each use
  instagram viewer
  shower gain weight. This means that fewer bacteria get into the pool.
• It is practical if you use the area around the pool Tiles cover or concrete. So it is always possible to go into the water with clean feet.
• When planning, you should also think about suitable coverage. This will prevent leaves from falling into the water. These instructions provide you with information on planning and implementation.

Planning a hot tub in the garden

1. Find a flat surface that is suitable for erecting the hot tub according to the building instructions. You then have to concret the area with a load-bearing concrete surface.


Build a hot tub - instructions for building in the garden

Make your garden an El Dorado for wellness lovers. This is quite simple, …

2. It is important that you have an electrical connection close to this place. So you can get electricity for the pool pump and heater and connect everything when it's done according to the instructions. You can also make the power connection safe if you integrate an FI switch.
3. You can then fill in water with a garden hose. Remember, you will need a sewer pipe that will lead to the public sewer. In this way, the wastewater can flow away unhindered.

Instructions for assembling the pool

1. You can build a hot tub according to the instructions if you buy a prefabricated kit from a retailer. You only need to assemble the connections according to the instructions. The kit should then contain a tub, nozzles and an integrated suction system.
2. The tub is set up to dampen vibrations. You then have to align it horizontally with a spirit level so that it is also straight.
3. The water inlet simply has to be connected without further ado. The same goes for the water drainage.
4. You then have to assemble the technical components. The parts that are operated electrically must be adequately protected from water. Also make sure that you look good at that Electrics comes, this is helpful when maintenance work has to be carried out.
5. The intake grille then ensures good air circulation. This prevents the heat from building up when you have switched on the heating. Please note that the technology connection must then correspond to class IP54.