How do I lay PVC?

instagram viewer

For example, if you renovate your apartment today, you will sooner or later also end up with the floor coverings. Then the question arises as to the type of flooring. The most popular floor coverings are carpeting, laminate or PVC flooring. But even then the question arises, how do I actually lay PVC correctly?

You can also lay a floor made of PVC yourself.
You can also lay a floor made of PVC yourself.

What you need:

  • PVC covering
  • PVC glue
  • Glue spatula
  • Reason for detention
  • Floor filler
  • Floor laying knife
  • Skirting boards

Buy and prepare PVC

  1. If you are looking for a Flooring the end PVC have decided, you should measure your floor to be covered exactly. Then you can start looking for a suitable topping.
  2. Please don't forget to get the right glue right away.
  3. When you have found the topping, add ten centimeters to your measurements and do not leave it at home instead make sure that you roll out the topping and lie in a warm place for at least a day permit. This serves to make the relatively stiff surface supple.

Prepare the floor for laying

  1. While you let the PVC sit for a day, check out the Underground exactly on. If the floor on which the covering is to be applied is in a good and smooth condition, no preparations need to be made. However, if the surface is uneven and full of holes, it must be well prepared.
  2. You should then get a primer and a smoothly flowing floor filler. To brush Fill the floor with this primer and let it soak in for a few hours.
    3. CV covering - installation instructions

    Perhaps you are in the process of getting a new floor covering. Just …

  3. Now you can mix the filler according to the instructions and apply it evenly to the substrate, also according to the instructions. After a drying time of about a day, the surface should be sanded off well. After that, you should make the floor dust-free.

Laying the PVC

  1. Now take the topping and lay it out so that it covers the entire floor. You should always work with at least two people when doing this job.
  2. You should now fold back half of the covering. Be careful not to shift the surface. Now you can apply the glue to the floor as instructed.
  3. Let this tighten a little and now carefully place the folded back covering on the prepared surface. Now you have to smooth the base evenly so that no bubbles can form. The best way to do this is to use a metal roller.
  4. Proceed in the same way with the second part of the covering. Then it comes to cutting: Please work slowly and carefully here, because you know that too much can be cut off, but too little can no longer be attached. When cutting to size, please leave a gap of around 3 millimeters along the walls, because the covering works during the drying process. The small distance that may remain to the wall can then be covered well with wall strips. If the covering has expanded, please recut.
  5. As a conclusion, the wall strips are now attached. There are also different materials here. It is made out of PVC wood or made of plastic. To the Assembly you will then need a miter saw for precise processing.

How helpful do you find this article?

click fraud protection