Paint plywood with wood preservative and colored varnish

What you need:

• 1 x screw clamp or vice
• 1 x sandpaper
• 1 x orbital sander
• 1 x sanding block
• 1 x spatula
• 1 x protective mask
• 1 x can of wood filler
• 1 x can of wood protection primer
• 1 x can of color varnish

Plywood is being prepared

These instructions show you how to prepare plywood with sandpaper and then paint it with colored varnish.

1. If you want to sand and paint plywood, you should find a room with a good supply of fresh air. So there should be at least one window to be available. To the ribbons you should also have the appropriate documents. A workbench would be ideal for your project.
2. After you have found the right space, you should lay your plywood in such a way that it cannot slip easily. In an emergency, they even have to clamp their plywood. Try to be as careful as possible not to let you do this wood to damage.
instagram viewer
3. Then you're good to go, take some sandpaper, an orbital sander, and sand down your plywood. Always try to sand in the direction of the grain. It is very important that you do not make deep grooves, so grind slowly and carefully.
4. If you get to a place where you can't get the orbital sander properly, use a small wooden sanding block. After you've completely sanded your plywood, run a dry cloth over the wood and remove any sanding dust.


Repainting the outside railing - instructions

An outside railing is exposed to pretty much all weather conditions that ...

Paint the sanded off parts

1. Before you can paint your plywood, you should examine the surface for damage. If you have found small holes, you should repair them with wooden filler. Then the filler is sanded in and you can start painting.
2. First, a layer of wood protection primer is applied. This primer prevents your plywood from being attacked by pests later and then helps the colored lacquer to adhere better. Let the wood protection primer dry properly.
3. After the primer has dried, you should roughen it again slightly. Then rub the plywood again with a dry cloth and paint the color varnish. Then all you need to do is let the color varnish dry and your plywood is ready.

At the To brush you should wear a protective mask.