Lay bitumen shingles on a roof pitch
Bitumen shingles are very popular as an alternative to slate shingles or normal roof shingles. Since they are easy to install on a roof pitch, you can also do the laying yourself.
What you need:
- waterproof film
- Bitumen shingles
- Bitumen sealant
- suitable spatula
- Craft knife
- hammer
- Roofing felt nails or nail gun
- Heat gun / gas burner
- ladder
Laying bitumen shingles is cheaper and less time-consuming than laying slate or clay roof shingles, especially when the roof is pitched.
Prepare your roof with a pitch
- Measure out the area of the roof that you want to cover with the shingles.
- Buy the appropriate insulation material and sufficient roof battens that you use as a substructure.
- Insulation First the roof if it is over the living area. If you only want to cover a garden house or shed roof, the insulation material is not required. In any case, you should apply a waterproof film here.
- Before the roof shingles are applied, you should definitely look for a stable substructure Roof battens Value.
- Once you have completed all the preparations on the roof, you should first place your roof shingles one below the other Mix, as color differences occur even with the same manufacturer and the same production number can.
Laying roof shingles - this is what you should pay attention to
When you build a new gazebo, the roof must protect against the weather ...
How to bring up the bitumen shingles
The higher the slope of your roof, the more nails you will need. You should also work with bitumen adhesive here.
- Now lay the first row of your shingles. To do this, start flush with the lower edge of the roof. Cut the web so that you start with a full clapboard.
- The roof nails are only hammered in so far that they touch the shingles, but do not penetrate the material. The nails are approx. Impacted 2 cm above the incision every 2.5 cm.
- For the second row, shorten the first clapboard in half so that the butt joints do not meet those from the first row.
- The second row should overlap the first so far that the lower edge of the row of shingles is flush with the incisions in the first row.
- Now continue to lay the bitumen shingles on your roof pitch, offset and overlapping.
- You should glue your shingles with bitumen glue on the edges and areas that touch the wind.
- Depending on the manufacturer, it may be necessary that you also have to treat the shingles with a gas burner.
- Do not hammer in more nails than necessary. Through the holes that are created, you offer real holes for moisture to penetrate.
Even if your first sheet of bitumen shingles may be on one roof If you don't succeed straight away with a pitched roof, you will get more practiced with each row.
How helpful do you find this article?
