Mount the license plate frame on the car
Today, so-called license plate frames are mostly used together with license plates, which are intended to enable the license plate to be replaced more quickly.
What you need:
- Drill with 6 mm drill
- screwdriver
- two screws 6 x 20 mm each with nuts and washers for both license plate holders
This is how a license plate frame is mounted
A license plate frame on the car should not only serve to advertise a car dealership, but also paint Protect the vehicle from scratches caused by vibrating license plates. In addition, when using license plate frames, no holes need to be drilled in the license plates.
- Before you start drilling holes in your vehicle, it is best to determine whether there are already openings or even threads for attaching the license plate frame. If this is the case, you can screw the license plate frame directly there. The license plate frames have a large number of possible mounting holes for a wide variety of vehicles, so that there are certainly the right holes for your vehicle.
- If your car does not have holes for this purpose, you will have to drill some yourself. To do this, look on the inside of the trunk to see whether you can drill anything by drilling the holes damage, and find the appropriate mounting holes on the license plate frame the end.
- Then drill two holes with a diameter of 6 millimeters in these places. Afterwards, it is best to remove the chips that have arisen as a result.
- Now screw the license plate frame to the corresponding point on the vehicle.
- In principle, you can proceed in the same way with the front license plate holder. Because of the optics, just make sure that the license plate holder is attached exactly in the middle of the vehicle. A corresponding point on the bumper to which the license plate holder can be screwed may also be provided here.
Attach curtain rails yourself - this is how it works
Before you can hang your curtains in front of the window, you have to ...
How helpful do you find this article?
