Rent for an attic apartment
In many regions, renting an apartment is a considerable item of the fixed expenses that you have to face every month. Therefore, especially if you are planning to live in your new domicile for years, you should check whether it is correct.
What you need:
- Lot
- Folding rule
The estimated rent for an attic does not necessarily have to be valid
- The rent for an apartment is a fixed quantity and is necessary for renting an apartment rental contract determined, however, you have the right to determine the related square footage of the property to be rented Check the living space in order to negotiate a change in the rent in the event of extreme deviations can.
- If the apartment for which you want to check the living space is an attic, you will have to do more work in measuring it out must invest, because for living space of this type there are very special deduction options in relation to the actually available Area. Here it is not only important to consider the floor area alone, but also the height of the individual Room, with your main focus on the slopes that are common in an attic judge is.
Measuring an attic apartment can be more than worthwhile in years to come
- You should know that in the case of an attic apartment, the number of square meters to be used to calculate the apartment rent cannot be calculated from the measured area of the floor alone. There are fixed specifications here as to the ceiling height from which the area below can be counted as living space at all.
- In the case of an attic, there is also the fact that it cannot be fully used in the area of the slopes, as you neither stand nor walk in certain areas or only to a limited extent furniture can set up. Therefore, there is also the option of only half of the area lying in a sloping roof or not at all, which in turn significantly reduces the amount of space required rent can bring living space to be used.
- In order for a floor area to be rented out as a fully-fledged living space, the distance between the floor and the ceiling must be at least 2 m.
- If the height, which will occur in sloping ceilings, is just 1 m, you can completely subtract the area below from the living space.
- The area that lies between the 2-meter limit and the height of one meter may not count as more than half of the living space.
What counts for living space? - How to correctly calculate the square footage
You would like to measure your living space to make sure that - the ones in the lease ...
Determining the areas to be deducted in practice
- In order to carry out the measurement correctly, you should mark the relevant soil areas in order to be able to determine how large the individual deductions may be. To do this, take a plumb bob and measure it so that the string and the tip of the plumb bob are one meter long.
- Use the end of the twine to run down the sloping roof towards the floor until the tip of the plumb bob touches the floor. Mark this support point and determine the length to the wall.
- Then measure the width of the wall in question and you can now use these two length measurements Determine the number of square meters that are not taken into account when calculating the apartment rent allowed.
- You now use the same procedure with a plumb line length of 1.99 m and the result is the number of square meters, only half of which can be counted. Please note here that you only measure up to the marking in the direction of the wall that you have already deducted.
- Repeat these two steps on every slope in your home.
- Finally, it is now a matter of determining the entire floor area of the apartment as a basis for calculation.
- From this you now subtract the areas to be deducted and have thus determined the correct living space to be used for calculating the apartment rent.
How helpful do you find this article?
