Replace antenna cable with radio

Analyze first, then replace the antenna cable

• In the beginning you should determine exactly how far apart the transmitter and receiver are and how much There are obstacles in between, because this is the basis of the purchase decision for the right one Radio transmission set. The more obstacles there are in between and the further the distance, the more you should pay attention to quality. If you are not sure, ask for advice from an electrical retailer before buying. This is because the manufacturer's information on the transmission range often relates to unobstructed routes. The more difficult the path, the higher the quality the equipment used should be.
  instagram viewer

• Note that both the transmitter and the receiver require power. Make sure of this.

• To replace the antenna cable, all necessary connections must be available on both the radio set and the connected television. Usually these are stereo Audio- and composite connection, as well as SCART. Your television should be equipped accordingly.

Set up devices and transmit signals via radio

1. Read the operating instructions for the radio transmission system carefully. Even if many systems are alike, there are still differences.
2. First install the transmitter and connect it to the cable TV socket or the antenna socket instead of the antenna cable. If you need an external receiver, i.e. not permanently installed in the television, to use a To decode satellite or digital signal, this should be at the transmitter and at this be connected. Transmission sets with an integrated cable tuner are particularly convenient. Then follow the information in the operating instructions.


VGA with radio transmission - you should pay attention to this

VGA systems with radio transmission like to promise that you no longer need cables for ...

3. If a receiver is in use, the infrared (IR) signal for the remote control must also be transmitted. Most radio transmission systems are equipped for this. Then install the corresponding IR module nearby, preferably within sight of the receiver. If possible, attach it firmly, or at least hold it in place. In the case of the receiver, this can also be present in the housing itself.
4. Install the receiver and turn on all the devices, because now it's time to fine-tune.
5. Most radio sets have four channels and one or two directional antennas. Put both devices on the same channel. Align the antennas differently and check the quality of reception. Repeat this until the reception is perfect.
6. Try out the available channels and antenna positions one after the other. It can also help to set up the devices as high as possible in the room. Don't get discouraged if it doesn't work right away. Sometimes it is enough to move the antennas just a little to improve the quality of the transmission considerably. Good succeed!