How to clear a deep-seated clog in the toilet
A clogged toilet is almost always due to unreasonable use. To avoid major damage, quick action is important. Mechanical and chemical means can be used.
How to clear a deep-seated clog in the toilet
The first measure in such a case is to block the flush so that no more water aggravates the flooding. The shut-off valve can be found on the cistern. Is this behind the tiles, you have to remove the operating unit. This is usually done by sliding the component left or right to disengage the clips.
What opportunities do you have to be successful
Of course, as an unsuspecting helper, you don't know which foreign body is causing the problem. If it is a relatively solid body, mechanical force is usually the only solution. There is the positive pressure method for this, or you need some kind of flexible shaft that can dig into the plug. In the case of a material that can be destroyed by chemical influences, treatment with aggressive solvents would promise success. However, this process takes time and is only possible if the toilet can remain closed for several days. There is no guarantee of success under any circumstances.
Be careful with highly caustic cleaners
If you want to try a pipe cleaning agent, be sure to follow the instructions on the packaging. Most people think that lots of cleaner makes for a quick fix. However, an overdose of the concentration causes a strong development of heat in the drain pipe. This can cause a leak in the plastic material, making the damage worse.
This is how the pump works
Various models of pressure devices are available in specialist shops, which create a pressure wave in the drain pipe. Such a sufficiently strong pressure wave can sometimes loosen the blockage and flush it into the sewer. A good seal of the rubber plunger in the toilet bowl is important. The bowl should have normal water level and you need to jerk the tamper down the drain. The less water left in the bowl, the greater the effect.
The special tool
Metal snakes, which can also be equipped with milling tools or hooks, are sold in specialist shops under the designation "pipe chain". But such a snake for the toilet has to be very filigree and flexible so that you can get around the bends in the drain with it. The blockage is almost always on the top knee and not at the lowest point of the siphon. It is best to work in pairs: one person guides the line in the right direction, the other Person operates the flanged crank to get the tip of the snake caught in the stopper can. If resistance is felt, pull the snake out while turning it further. The operation is successful if the flushing water then drains normally again because the stopper is hanging on the snake.
If your sink or sink is clogged and the water is poor or non-existent...
In the most stubborn case, when all attempts fail, your only option is to contact an installer who is familiar with such problems. But even the specialist is sometimes forced to destroy the toilet because there is no other solution.
