Erect a garden wall from sand-lime brick

instagram viewer

In the event that you want to demarcate two gardens, for example, you can easily build a garden wall from sand-lime brick. This is possible even without experience.

You can easily build a wall yourself.
You can easily build a wall yourself.

What you need:

  • Screed concrete
  • formwork
  • Sealing sludge
  • mortar
  • Sand-lime bricks
  • Guideline
  • Spirit level
  • Float
  • Joint iron

Building the foundation for your garden wall

If you have a Garden wall If you want to build from sand-lime brick, you must first make the foundation for the wall.

  1. In order to be able to erect the foundation, you must first determine exactly where the wall should run along. Now stretch a string so that the course of the wall is marked. Remember that adjoining properties may not be built on.
  2. After you have determined how long and how wide the wall should be, you can now dig the ground. They need about a depth of 50-70 cm. How wide you need to build the foundation depends on how wide you want to build the wall. The foundation should be about 10 cm wider than the width of the wall.
  3. Then you can also mix the screed concrete. Depending on which brand you use, the concrete is mixed with a different mixing ratio.
  4. Since part of the foundation must also be visible above the ground, you now have to attach a border or formwork. So that the wall does not get crooked, it is advisable to work with a spirit level when attaching the formwork.
    5. Use concrete shuttering blocks to build a garden wall

    To build a garden wall, you can use normal hollow blocks or you ...

  5. Finally, pour in the remaining concrete and straighten it with a float.
  6. When the foundation is completely dry, you can still seal it with waterproofing slurry. This is to prevent moisture from penetrating the concrete.

Wall with sand-lime brick

After you have built the foundation, you can now build your garden wall with sand-lime brick.

  1. To do this, apply the mixed mortar to the dried foundation.
  2. Then you need to put a sand-lime brick on both the left and right ends.
  3. Now stretch a guideline so that the course of the wall is straight.
  4. Now always apply some mortar to the side of a moistened sand-lime block and then apply it to a block that has already been set. In the event that you want to set the wall in a half-stone bond, you have to offset the stones half a stone's width to the lower joint.
  5. Before the mortar dries, you should use a joint iron for approx. Scrape out the mortar 1.5 cm deep.

How helpful do you find this article?

click fraud protection